EME Atwell Labelling Machine

Introduction

This tutorial provides a comprehensive guide to setting up the EME Atwell labelling machine, as showcased in the S.C. Packaging Technology video. Whether you are a beginner in packaging technology or looking to enhance your operational efficiency, this step-by-step guide will help you understand the setup process and effectively use the labelling machine.

Step 1: Unpacking the Labelling Machine

• Carefully remove the labelling machine from its packaging.
• Ensure you have all components, including:
  • Control panel
  • Label roll holder
  • Conveyor belt
• Inspect for any visible damage during transport.

Step 2: Setting Up the Machine

• Position the labelling machine on a stable, flat surface.
• Connect the power supply:
  • Plug the machine into a suitable electrical outlet.
  • Ensure the voltage matches the machine specifications.
• Attach the conveyor belt if not pre-installed:
  • Align the conveyor with the machine base.
  • Secure it using the provided screws.

Step 3: Loading Labels

• Open the label holder to access the spindle.
• Place the label roll onto the spindle:
  • Ensure the labels are facing the correct direction.
• Feed the label through the machine's rollers:
  • Pull the label until it reaches the dispensing area.

Step 4: Calibrating the Machine

• Access the control panel:
  • Turn on the machine using the power switch.
• Set the label size:
  • Use the control panel to select the desired label dimensions.
• Test the dispensing mechanism:
  • Run a few labels to ensure proper alignment and spacing.

Step 5: Adjusting the Speed

• Locate the speed control settings on the control panel.
• Adjust the conveyor speed based on your production needs:
  • Start with a moderate speed and increase as you gain confidence.

Step 6: Conducting a Test Run

• Before full operation, perform a test run:
  • Place a few products on the conveyor.
  • Monitor the labelling process for accuracy and efficiency.
• Make any necessary adjustments to the label alignment or speed based on the test results.

Conclusion

Setting up the EME Atwell labelling machine is straightforward if you follow these steps carefully. Always ensure safety by checking for any electrical issues and proper alignment of labels. For ongoing operations, monitor the machine's performance and make adjustments as needed. With this setup, you'll be well on your way to efficient labelling in your packaging process.